UE Systems Remote Access Sensors

When accessibility is an issue, such as when a motor is contained within a closed cabinet, or a test point is in a hard-to-reach area, the Remote Access Sensor is the answer.

ENQUIRE ABOUT THIS PRODUCT

PRODUCT INFORMATION
TECHNICAL SPECIFICATIONS

Mount the Remote Access Sensor on the test point and run a cable to an access area where a RAM (Remote Access Module) can be connected. When the point is to be tested, plug the RAM into your Ultraprobe and take your reading. Installation is very simple and testing is really easy! Just mount the RAS transducer on your test subject, attach a BNC cable, run the cable through an access hole. Now, every time you come by, just plug it into your Ultraprobe 9000, 10.000, 15.000 or 401, record your data and move on. If you have multiple bearings on hard-to-reach areas, you can even make use of UE Systems’ Switch Boxes which will allow to test up to 8 bearings at once! We don’t just sell products, we offer a fully comprehensive service to compliment your maintenance program. Please contact us to find out more.

Transducer Piezoelectric, stainless steel housing with female BNC connector
Dimensions Dia. 1.0″ (2.54 cm) Length: 2.4″ (6.1 cm)
Thread (female) 10/32
Cable BNC connector, 25 ft (7.6 m) standard. Can be ordered up to 50 ft. (15.2 m)
Preamp Electronics are designed to interface with Ultraprobe 9000, 10.000, 15.000 and 401 models only
Frequency Response 20 kHz – 100kHz
Operating Temperature 32° – 140°F (0° – 60° C)